The short answer: Weeds keep growing between pavers because the joint sand has washed out and wind-blown soil and seeds have settled into the gaps, giving them a seedbed. Pulling or spraying only removes this week’s crop. In Pocopson Township, the lasting fix is a professional cleaning that clears the soil out of the joints, followed by fresh joint sand swept in and set, and a sealer that helps hold it in place.
In This Guide
Why Do Weeds Keep Growing Between Pavers?
Weeds do not push up from under the pavers. Unilock, the paver maker, explains that they grow between the stones once the jointing sand washes away and leaves room for seedlings to fall in.
An empty joint does not stay empty for long. Wind carries dust, leaf bits and grass clippings into it, rain packs them down, and within a season the gap holds a thin layer of soil. That soil stays damp and shaded between the stones.
Seeds find it quickly. Clover, crabgrass and moss are usually first, followed by tree seedlings from nearby maples. Their roots spread sideways along the joint and can loosen the edges of the pavers over time.
Ants add to the trouble. Their tunnels lift sand out of the joints in small mounds, and every grain they move leaves more room for soil. A patio with ant hills along its seams is usually losing sand faster than it looks.

Where Does the Joint Sand Go?
Rain, runoff and foot traffic slowly carry it out of the joints. Downspouts that empty onto a patio and cleaning done with too much pressure speed that loss up sharply.
Slope matters a great deal. Unilock stresses sloping a patio away from the house so water drains instead of sitting, and a patio that drains poorly loses sand where water pools and flows. Low corners and the edges along beds usually empty first.
Older patios show it most. Sand that was full and firm on installation day settles and thins with each season of freeze and thaw. Once the joint drops below the paver edge, wind and water have an easy channel to work in. Around Pocopson, patios on sloped lots tend to lose the most sand along the downhill edge.
Why Doesn’t Pulling or Spraying Ever End It?
Pulling and spraying deal with the weeds and leave the seedbed in place. As long as the joint holds soil and moisture, new seeds land, sprout and fill it again within weeks.
Pulling also takes soil and sand with the roots, which leaves the joint emptier than before. Sprays kill what is green but do nothing about the dirt underneath, and repeated spraying near beds and lawns carries its own risks.
- Joint sand sitting well below the top edge of the pavers
- Dark soil and leaf debris packed into the gaps
- Moss filling joints in shaded corners of the patio
- Puddles that stand in low spots after a storm
- Downspouts emptying straight onto the hardscape
- Tree seedlings rooting along the patio edge
Plastic sheeting under the pavers is another false fix. Unilock warns that plastic keeps the joints wet and actually promotes weed growth, the opposite of what the installer intended. Weedy joints usually point to one or more of the conditions below.
Tired of pulling the same weeds every month? Colony Pressure Washing is a family-owned pressure washing in West Chester that cleans paver joints, sweeps in fresh sand and seals the surface edge to edge. Call (484) 345-1999 or request a free quote online.
How Does a Professional Cleaning Clear Out the Joints?
The crew reads the pavers first, then deep cleans the surface and the joints with the pressure the paver can take. Soil, moss, roots and old weeds come out of the gaps along with the dirt and black film on top.
This is the one time washing sand out of the joints is the goal. The soil-filled layer has to go, and new sand cannot be added on top of it. Rinsing works from the house outward so the debris leaves the patio instead of settling into the next row of joints.
Afterward the pavers have to dry completely. Sand will not settle properly into damp joints, and sealer cannot go over wet stone. Colony Pressure Washing usually handles cleaning and sealing as two visits for that reason. The haze that sometimes appears on new concrete pavers is a separate issue, covered in this look at the white haze that forms on new pavers.
Edges get extra attention. Where pavers meet a lawn or a planting bed, roots creep in sideways, so those border joints are cleared deeper than the rest.

How Do Re-Sanding and Sealing Close the Joints?
Fresh joint sand is swept in until the gaps are full, then set so it locks the pavers together. A sealer applied edge to edge helps hold that sand in place and slows water from washing it back out.
Full joints leave seeds nowhere to root. With sand right up to the edge of each paver, wind-blown dust has no pocket to collect in, and anything that does land gets swept off with the next rain.
Traffic stays off the patio while the sealer cures. Glossy and matte sealers look very different in afternoon light, so the homeowner picks the finish at the quote. No joint stays perfect forever, but a cleaned, re-sanded and sealed patio keeps weeds to a minimum for years instead of weeks.
Who Restores Weedy Paver Joints in Pocopson Township?
In Pocopson Township, Colony Pressure Washing restores weedy patios and walks with a clean, fresh joint sand and a sealer coat, and every job starts with a free on-site quote. Patio size, rust or oil marks, leftover sealer and the depth of the empty joints all shape that number.
The township’s homes come from many eras, with census estimates counting 183 built in the 1970s, 164 in the 1980s and 151 in the 1950s. Open land is close at hand too. In October 2008 the township took over 68 acres from Chester County at Lenape-Unionville and South Wawaset Roads, and the Northbrook and Trimbleville villages each have a historic district listed nationally.
Every stage of the work is set out on Colony’s paver washing, sanding and sealing page. Township specifics sit on the Pocopson service area page. Adding the front walk to the patio visit usually costs less than a second booking.







